Teledyne 465L Instrukcja Użytkownika Pobierz pdf (Strona 26)

Teledyne API Model 465L O

Monitor Operation Manual

24 05509F DCN6409

Figure 4-4: Pneumatic Connections, NEMA Configuration, Multi-Stream

4.1.1. Sample Gas Connection

Sample gas connections are made to the ¼” tube fittings on the rear panel. For single stream

monitors, use the fitting labeled “Sample Inlet.” For multi-stream monitors, the sample tubing is

connected to the fittings labeled Stream 1, Stream 2, etc (See Figure 4-2, Figure 4-3, Figure 4-4)

1/4" O.D. FEP (Teflon) tubing is recommended to connect the sample source to the monitor.

Any fittings used in the sample lines should be constructed of stainless steel or Teflon.

Teledyne API recommends that the length of tubing connecting the sample points to the monitor

should be kept to 50 feet or less.

NOTE

For the sampling lines, use only ¼” O.D. FEP tubing. For best analytical performance, the

tubing should be pre-conditioned to ozone prior to installation to minimize ozone loss in the

sampling lines. Pre-conditioned ¼” FEP tubing is available from Teledyne API (Part number

02639)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 91 92

Brak uwag

Teledyne 465L Instrukcja Użytkownika Strona 26